- One of the smallest recording altimeters
- Tiny: 0.365" x 0.485" (9.3 x 12.3mm)
- Only weighs 0.6g (without battery)
- Fits into 10.5mm tubes
- Bright red LED
- 3-pin connector for bidirectional communication or telemetry
- Firmware is field upgradeable by user
- Can be used in model rockets, weather balloons, kites, model airplanes,
etc.
- Measures up to 100,000 ft. (30.5km) MSL
- Resolution is 8" (20cm) at sea level
- Very low power: 150µA (average) @ 3V (depends on sample rate)
- Supply voltage: 2.2V - 3.6V (3.0V recommended)
- Suggested power source: CR1025 or CR927 coin cell (battery holder not
included)
- Records air pressure and temperature
- Data compression to increase recording capacity (typically 2500 samples)
- User selectable startup delay, launch detect altitude, sample rate, etc.
- Recorded data is non-volatile, and only erased when explicitly requested
(not from accidental loss of power due to intermittent connection)
- Contest directors will appreciate the tamper-resistant downloaded data
file that includes byte-for-byte verification of the firmware version
- Includes host software for MS Windows; version for Android planned for
future
- Conformal coating for protection
- 4-layer PCB for better EMI immunity
- Requires
USB-HalfWire communication module
(available separately) to erase, arm, download, update, etc.
- (Model name, specifications, and prices are
only preliminary and subject to change)
- (Not yet available for sale -- refer to
notes.)
|
